– 255 –
CHAPTER 3 System Messages
4-W: TSW Ready Failure Restore
This message is displayed when TSW Ready failure is restored.
Information on TSW Ready failure
restoration
Self CPU status after restart
Failure information
Default Alarm Default Grade Grade Modified Lamp Modified
MN 3
1: XXXX 0XX0 0000 0000 2: 0000 0000 0000 0000 3: 0000 0000 0000 0000
4: 0000 0000 0000 0000 5: 0000 0000 0000 0000 6: 0000 0000 0000 0000
7: 0000 0000 0000 0000 8: 0000 0000 0000 0000 9: 0000 0000 0000 0000
b7 b2 b1 b0
b7 b0
b7 b3 b2 b1 b0
1
2
3 4
b0: 0/1 = -/Failure restoration in TSW system 0
b1: 0/1 = -/Failure restoration in TSW system 1
b2: 0/1 = Failure restoration in TSW on even-numbered MG/
Failure restoration in TSW on odd-numbered MG
b7: 0/1 = TSW in normal state after restart/
TSW in abnormal state after restart
1
b0: 0/1 = -/Monitor restart
b7: 0/1 = ACT/STBY
2
b0–b3:Type of failure (HEX)
00= -
01= DLKC/PLO initialize failure
02= TSW ACT changeover failure
03= GT card abnormal
04= GT card abnormal (MB control abnormal)
05= TSW ACT changeover failure
06= GT card abnormal
07= GT card abnormal (MB control abnormal)
08= TSW ACT changeover failure
09= During fault processing
0A= During fault processing
0B= TSW ACT changeover failure
3
To Next Page
Loading...
