– 576 –
CHAPTER 5 Operation Procedure for System with PIR
2.4 Replacement Procedure of CF Card
Always backup the current program and office data stored in CF card before replacing
the CF card.
[Start]
STEP 1 Backup the office data stored in CF card and copy it into a reliable storage device.
STEP 2 Write in the program to the new CF card by referring to Installation Manual. Also, write in the
office data stored in the storage device such as a hard disk of a PC.
STEP 3 Shutdown the system, referring to “Initialization by Turning OFF and ON the System”.
STEP 4 Take out the fault CF card and insert the new CF card in which program and office data have
been written.
STEP 5 Turn ON the system again, referring to “Initialization by Turning OFF and ON the System”.
STEP 6 Set the data and time by using ATIM.
[End]
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
CF card cannot be removed while the SV8500 is in operation. Doing so stops the system
operation.
WARNING
Be sure to use anti-static measures when handling a CF card. See “How to Handle a CF card”
for more details.
WARNING
To Next Page
Loading...
