– 672 –
CHAPTER 5 Operation Procedure for System with PIR
5.6.2 SV8500 Server Power ON/OFF Procedure
[AC-Powered Model of SV8500 Server]
Turn ON:
STEP 1: Connect an AC power code to AC inlet on Power module (on the rear panel of
SV8500 server module).
STEP 2: Turn on the PWR switch (to left) (
Note 1). PWR lamp (on the left of Power switch) lights green.
Turn OFF:
STEP 1: On PCPro Tools menu [System Control], select [System Shutdown] and click the Execute button.
SV8500 server stops operating here.
Note 2
STEP 2: Turn off the Power switch (to right) on the Power module.
STEP 3: Disconnect the AC power code.
[DC-Powered Model of SV8500 Server]
Turn ON:
STEP 1: Supply the power to BASEU. When the power cable between BASEU and SV8500 server is connect-
ed, BASEU starts supplying the power to SV8500 server here.
STEP 2: Turn on the Power switch (to left) on the Power module (on the rear panel of SV8500 server module)
(
Note 1). PWR lamp (on the left of Power switch) lights green.
Turn OFF:
STEP 1: On PCPro Tools menu [System Control], select [System Shutdown] and click the Execute button.
SV8500 server stops operating here.
Note 2
STEP 2: Turn off the Power switch (to right) on the Power module.
STEP 3: Stop supplying the power to BASEU.
Note 1: When you want to turn on SV8500 server right after turning off the powered system, wait for a while (about
10 seconds) before powering on the system again.
Note 2: Check the PWR lamp on the front panel of CPU card turns off. When the system is dual configuration, check
the PWR lamp goes off on both #0 and #1 CPU cards.
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
To Next Page
Loading...
