– 915 –
CHAPTER 7 Maintenance Commands
SRTS_LR: Scanning of Route Status - Logical Route Number
1. Functional Outline
This command is used to display the designated trunk status (IDLE/BUSY) at predetermined intervals. A
maximum of 15 routes can be scanned. Route number of the SRTS command can be assigned by using a logical
route number.
Note: When logging in to the Network Control Node (NCN), the data of the other Local Node (LN) can be
changed. If logging in to a LN, only the DM of self-node can be changed by this command.
2. Parameters
Input Data
LGRT: Logical route Number [1-899]
Note
Interval: Interval Time of two scan [2-999]
Note: Prior to this command, a logical route number must be allocated by the ALRTN command.
Output Data
FPC: Fusion Point Code [1-253]
RT: Route of Route Number
Number of IDLE/BUSY TK
To Next Page
Loading...
