– 906 –
CHAPTER 7 Maintenance Commands
SINZ: System Initialize
1. Functional Outline
This command is used to initialize the system from PCPro.
WARNING: Do not use this command when the system is in normal operation since this command ex-
ecutes the system initialization.
Note: When the system is initialized, PCPro is disconnected. After initialization is complete, log back into
PCPro.
2. Parameters
<TYPE tab>
System Initialize
The system initialize is executed for ACT side with the current office data of MEM without loading
from the CF card.
Office Data Load & System Initialize
The system initialize is executed for ACT side by loading the office data from the CF card to MEM.
Program & Office Data Load & System Initialize
The system initialize is executed for ACT side by loading the program and the office data from the CF
card to MEM.
<OPTION tab>
Calling keep restore
The system initialize is executed for ACT side while maintaining a call in progress.
Restart
The system initialize is executed for ACT side by restarting the system.
Shutdown
The system initialize is executed for ACT side by shutting the system down.
<Standby> System Initialize
Note 1
The system initialize is executed for STBY side with the current office data of MEM without loading
from the CF card.
<Standby> Office Data Load & System Initialize
Note 1
The system initialize is executed for STBY side by loading the office data from the CF card to MEM.
<Standby> Program & Office Data Load & System Initialize
Note 1
To Next Page
Loading...
