– 232 –
CHAPTER 3 System Messages
1-V: DLKC Data Transfer Failure (Temporary)
This message displays when a data sending error or no answer error occurs at the time of data transfer from CPU
to DLKC card.
System status of faulty DLKC card
Error Code
Details on Switching Network
Note: This data displays when the STBY DLKC card is detected as faulty.
Default Alarm Default Grade Grade Modified Lamp Modified
SUP 1
1: XXXX XX00 0000 0000 2: 0000 0000 0000 0000 3: 0000 0000 0000 0000
4: 0000 0000 0000 0000 5: 0000 0000 0000 0000 6: 0000 0000 0000 0000
7: 0000 0000 0000 0000 8: 0000 0000 0000 0000 9: 0000 0000 0000 0000
b7 b0
b7 b6 b5 b4 b3 b2 b1 b0
b7 b1 b0
1 2
3
b0: 0/1 = System 0/System 1
1
01H: Firmware fault
02H: Data transfer time out to DLKC
03H: No answer time out (at DLKC)
04H: Data parity error
2
b0: Status of Speech Path System (including DLKC)
0/1 = System 0 is ACT/System 1 is ACT
b1: Status of basic clock
0/1 = System 0 is ACT/System 1 is ACT
b7: Information on Reset of STBY DLKC Note
0/1 = - /STBY DLKC card was reset
3
To Next Page
Loading...
