– 669 –
CHAPTER 5 Operation Procedure for System with PIR
5.5.2 Class Change and Number Change of Station and Data Terminal
Figure 5-36 shows the procedure for class change and number change of station and data terminal.
Figure 5-36 Class Change and Number Change of Station and Data Terminal Procedure
5.5.3 Make-Busy/Make-Busy Cancel of C.O. Line/Tie Line
Figure 5-37 shows the procedure to make-busy/make-busy cancel of C.O. line/tie line.
Figure 5-37 Make-Busy/Make-Busy Cancel of C.O. Line/Tie Line Procedure
• For changing class, use ASCL command
• For changing station number, use ASTN command
START
Line Make-Busy
Class change and number
change
Line Make-Busy Cancel
END
END
• For make-busy/make-busy cancellation by line basis
MBLE command
• For make-busy/make-busy cancellation by route basis
MBRT command
• For make-busy/make-busy cancellation by each circuit
card (Except for PHL)
MBPM commands or MB (toggle) switch setting on the
circuit card
• For make-busy/make-busy cancellation by each PHL
MBPH commands or MB (toggle) switch setting on the
PHL circuit card
Note: Before make-busy/make-busy cancellation, make
sure the status by using DPHL command
START
Make-Busy/Make-Busy Cancel of
C.O./Tie Line
To Next Page
Loading...
