NEC UNIVERGE SV8500 - J Bandwidth Fault Recovery

– 509 –
CHAPTER 3 System Messages
36-J: Bandwidth Fault Recovery
This message displays when reserving enough of the bandwidth resource [for two calls calculated by G711
(sending period 10ms)] after the bandwidth fault has terminated the bandwidth restriction. Output of this
message can be controlled by using the office data settings (ABNDL). For more details refer to Office Data
Specifications.
A Location ID
B Location ID
Default Alarm Default Grade Grade Modified Lamp Modified
NON
1: XXXX XXXX 0000 0000 2: 0000 0000 0000 0000 3: 0000 0000 0000 0000
4: 0000 0000 0000 0000 5: 00 0000 0000 0000 6: 0000 0000 0000 0000
7: 0000 0000 0000 0000 8: 0000 0000 0000 0000 9: 0000 0000 0000 0000
b7 b6 b5 b4 b3 b2 b1 b0
b15 b14 b13 b12 b11 b10 b9 b8
b7 b6 b5 b4 b3 b2 b1 b0
b15 b14 b13 b12 b11 b10 b9 b8
1
2
b0-b15 = A Location ID that recovered from the bandwidth fault
1
b0-b15 = B Location ID that recovered from the bandwidth fault
2