NEC UNIVERGE SV8500 - L Emergency Control Start

– 272 –
CHAPTER 3 System Messages
6-L: Emergency Control Start
This message displays when the LCR-Attendant Manual Override is set at the Attendant Desk Console.
Route Selection Time Pattern
number assigned at Attendant Desk
Console
Note: Route Selection Time Pattern 0-7 corresponds to TDPTN 0-7 in the AOPR command.
Default Alarm Default Grade Grade Modified Lamp Modified
NON 3
1: XX00 0000 0000 0000 2: 0000 0000 0000 0000 3: 0000 0000 0000 0000
4: 0000 0000 0000 0000 5: 0000 0000 0000 0000 6: 0000 0000 0000 0000
7: 0000 0000 0000 0000 8: 0000 0000 0000 0000 9: 0000 0000 0000 0000
b7 b2 b1 b0
1
b0-b2: Pattern (1-7)
1