NEC UNIVERGE SV8500 - MEM_HDD_N Data Control between Memory and HDD for Fusion Network

– 891 –
CHAPTER 7 Maintenance Commands
MEM_HDD_N: Data Control Between Memory and HDD for Fusion Network
1. Functional Outline
This command, available at the NCN only, is used to save/verify a series of Office Data from the Memory of all
Local Nodes to the Flash Card of each same node.
Note: You can install/verify the data onto the Flash Card of all the node on the FCCS network (Maximum 64
nodes).
2. Parameters
Input data
Direction Select: Memory to Hard Disk
Verify HDD against MEM
Data Type Selection: Data Memory
Note 1
Name Display
Wireless Call Forwarding
Call Forwarding
Speed Calling
User Assign Soft Key
Number Sharing
Note 2
ACD Data Memory
Call Block
ICB and DR
Expanded Speed Calling
Call Forwarding-Logout
One Touch Speed Calling for DtermIP
Message Area ID Data
SR-MGC Data
SIP Terminal Call Transfer
Note 4
Mobility Access Data
Day/Night Data
Local Phone book Data
All Select: Check this box when selecting all the data types listed in the “Data Type Select” field.
When individually selecting a specific number of data types, leave the box unchecked
(and specify the type(s) in the “Data Type Select” field).
LP Select: The parameter is valid when “Call Forwarding”, “Speed Calling”, “User Assign Soft
Key”, “Number Sharing”, “Call Block”, “ICB and DR”, “Expanded Speed Calling”,
“Call Forwarding-Logout” or “Mobility Access Data” is designated.
Auto Verify Afterward: Automatically verify the data after being copied.
Auto Scroll: Refresh the Processing Status Log
< For “Redundant Data Memory Backup on Individual Hard Drive” >
Note 3