– 849 –
CHAPTER 7 Maintenance Commands
DTF104N: Display of Attendant Peg Count Data for FCCS Network
1. Functional Outline
This command is used to display the result of traffic measurement data for TYPE=4 (ATT Peg Count) assigned
by the ATRFN command.
2. Parameters
Traffic Data 1: Terminal Traffic-DTF101N
Route Traffic-DTF102N
Station Peg Count-DTF103N
Attendant Peg Count-DTF104N
Route Peg Count-DTF105N
Traffic Data 2: Service Peg Count-DTF201N
Traffic Data 3: UCD Route Peg Count-DTF301N
UCD Group Peg Count-DTF302N
UCD Station Peg Count-DTF303N
Traffic Data 5: Attendant Answer Peg Count-DTF501N
Traffic Data 6: Connection Route Peg Count-DTF601N
Connection Route Traffic-DTF602N
To Next Page
Loading...
