NEC UNIVERGE SV8500 - L SR-MGC State Notification

– 369 –
CHAPTER 3 System Messages
10-L: SR-MGC State Notification
This message displays when the state of SR-MGC is changed to Operating Mode or Stand-by Mode.
SR-MGC State Change Notification
When =01 (Change to Operating Mode)
Kind of State Change
Default Alarm Default Grade Grade Modified Lamp Modified
NON
1: XXXX XXXX XXXX XXXX 2: XX00 0000 0000 0000 3: 0000 0000 0000 0000
4: 0000 0000 0000 0000 5: 0000 0000 0000 0000 6: 0000 0000 0000 0000
7: 0000 0000 0000 0000 8: 0000 0000 0000 0000 9: 0000 0000 0000 0000
b7 b6 b5 b4 b3 b2 b1 b0
b7 b6 b5 b4 b3 b2 b1 b0
1
2
01H = Change to Operating Mode.
02H = Change to Stand-by Mode.
1
1
01H = Change of the state on startup
02H = Change of the state by network failure detection
03H = Change of the state by CMNT command
2