NEC UNIVERGE SV8500 - DLSS_T Display of Lock out Station - Number - Telephone Number

– 819 –
CHAPTER 7 Maintenance Commands
DLSS_T: Display of Lock Out Station – Number – Telephone Number
1. Functional Outline
This command is used to print out stations in lockout state, by using Telephone Numbers. This command is only
available at NCN (for FCCS network).
2. Parameters
Input Data
TYPE: Printout of all lockout stations
Printout of lockout stations by tenant
Printout of lockout stations within a specified range of station number
UGN: User Group Number
Note 1, Note 2
Start TELN: First Telephone Number (maximum 16 digits) Note 2
End TELN: Last Telephone Number (maximum 16 digits) Note 2
Note 1:
This parameter is valid when Type =Printout of lockout stations by tenant is selected.
Note 2: This parameter is valid when Type =Printout of lockout stations within a specified range of station
numbers is selected.
Output Data
FPC: Fusion Point Code (1-253)
TN: Tenant Number
Start STN: First Physical Station Number
(a maximum of five digits for a Business system, and six digits for a Hotel system)
End STN: Last Physical Station Number
(a maximum of five digits for a Business system, and six digits for a Hotel system)
CNT: Count
UGN: User Group Number
TELN: Telephone Number (maximum 16 digits)
LENS: Line Equipment Number
Buttons
Get: Get information on the lockout status.
Exit: Exit this command.