– 814 –
CHAPTER 7 Maintenance Commands
DISS: Display of Program Issue
1. Functional Outline
This command is used to output program information in the main memory and the Port Microprocessor (PM)
memory into a printer and PCPro: The program information includes Version, Issue No., Date, etc.
Note: DISS command should be run during low traffic only.
2. Parameters
Input data
Type of Issue: Main Memory
Port Microprocessor
Module Group (Module Group Number)
Note 1
Unit (Unit Number) Note 1
Output data
<When “Main Memory” is selected for “Type of Issue”>
Type (Program Name)
Ver si on
Issue
Date (Year/month/Day)
<When “Port Microprocessor” is selected for “Type of Issue”>
Group (Group Number) [00-31]
Firmware Information
SP/SW No. (SP/SW Number)[4 digits]
Issue
Note 1: This data is valid when Port Microprocessor is designated.
To Next Page
Loading...
