NEC UNIVERGE SV8500 - CCSE Change of Common Signaling Channel Equipment

– 735 –
CHAPTER 7 Maintenance Commands
CCSE: Change of Common Signaling Channel Equipment
1. Functional Outline
This command is used to set/reset the make-busy state of CCH circuit card.
2. Parameters
LENS: Line Equipment Number of CCH circuit card [five digits]
MG=XX, UNIT=X, GROUP=XX
LINK: Link Status [0-2]
0=Link Open
1=Link Close
2=Not Available
MB: Make-Busy Information [0-2]
0=Make Idle
1=Make Busy
2=Not Available
Note: This command cannot be used for ISDN-related circuit card (such as PRT, DCH card).