NEC UNIVERGE SV8500 - F Memory Failure

– 210 –
CHAPTER 3 System Messages
0-F: Memory Failure
This message displays when a CPU memory read/write error occurs.
Information on Self-CPU Restart
after detection of a clock fault
Mate-CPU Restart Information
NMI Factor
Reference: See section 4.7.1 on page 640, for the repair procedure.
Default Alarm Default Grade Grade Modified Lamp Modified
SUP 3
0-F Memory Failure
1: XXXX XXXX XXXX XXXX 2: XXXX XXXX XXXX XXXX 3: XXXX XXXX XXXX XXXX
4: XXXX XXXX XXXX XXXX 5: XXXX XXXX XXXX XXXX 6: XXXX XXXX XXXX XXXX
7: XXXX XXXX XXXX XXXX 8: XX00 0000 0000 0000 9: 0000 0000 0000 0000
b7 b5 b4 b3 b0
b7 b5 b4 b3 b0
b7 b6 b5 b4 b3 b2 b1 b0
1 2 3 4
5
6
7
8
8
8
b0: 0/1 = -/Monitor Restart
b3: 0/1 = -/Initialization
b4: 0/1 = -/Data Copy Restart (for Dual-CPU system only)
b5: 0/1 = -/MB Control
b7: 0/1 = ACT/STBY (active system indication after restart)
1
b0: 0/1 = -/Monitor Restart
b3: 0/1 = -/Initialization
b4: 0/1 = -/Data Copy Restart (for Dual-CPU system only)
b5: 0/1 = -/MB Control
b7: 0/1 = ACT/STBY (active system indication after restart)
2
b0: 0/1 = -/Reset by Power On
b1: 0/1 = -/Watchdog Timer timeout
b2: 0/1 = ISGAT is mounted/ISGAT is not mounted
b3: 0/1 = -/OSC clock interrupt on ISGAT
b4: 0/1 = -/IO parity Alarm
b5: 0/1 = -/IO ready Alarm
b6: 0/1 = -/External NMI
3