– 750 –
CHAPTER 7 Maintenance Commands
CMWL_T: Control Message Waiting Lamps – Telephone Number
1. Functional Outline
This command is used to control/display the Message Waiting Lamp’s ON/OFF status, by using Telephone
numbers. When the station is a Dterm, this command can also be used to control the Message Waiting Lamp
Display. This command is only available at NCN (for FCCS network).
2. Parameters
Input Data
TYPE: Designation by Telephone Number/Designation by LEN
UGN: User Group Number
Note 1
TELN: Telephone Number (maximum 16 digits) Note 1
LENS: Line Equipment Number Note 2
MWLAMP: MW Lamp Status OFF/ON
MCI: Message Center MW Status OFF/ON
ATT: Attendant Console MW Status OFF/ON
STA: Station MW Status OFF/ON
VMM: Voice Mail Module MW Status OFF/ON
Note 1: This parameter is valid when TYPE =1 is selected.
Note 2: This parameter is valid when TYPE =2 is selected.
Output Data
FPC: Fusion Point Code (1-253)
Note 3
TN: Tenant Number Note 3
STN: Physical Station Number
(a maximum of five digits for a Business system, and six digits for a Hotel system)
Note 3: These parameters are for display only.
Buttons
Get: Get information on the MW status.
To Next Page
Loading...
