NEC UNIVERGE SV8500 - CADSD Continuous Assignment of Station Data

– 717 –
CHAPTER 7 Maintenance Commands
CADSD: Continuous Assignment of Station Data
1. Functional Outline
This command can assign/delete many station data with consecutive numbers at once.
2. Parameters
Input Data
Type: Assign/Delete
[When Assign is selected in the TYPE selection list box]
TN(START): Start Tenant Number
TN(END): End Tenant Number
STN(START): Start Station Number [maximum six digits]
Note 1
STN(END): End Station Number [maximum six digits] Note 1
STEP: Station Count-up Step Note 2
If using asterisk (*) and number (#) o[1-12]
If not using asterisk (*) and number (#) o[1-10]
LENS(START): First Line Equipment Number [six digits]
LENS(END): Last Line Equipment Number [six digits]
GROUP(START): First Group Number [0-31]
GROUP(END): Last Group Number [0-31]
LEVEL(START): First Level Number [0-7]
LEVEL(END): Last Level Number [0-7]
Note 1: In the bottom part of the display, a check box is provided to determine whether to use “*” and “#” as
a part of the station number. If necessary, check the box.