– 718 –
CHAPTER 7 Maintenance Commands
Note 2: In the parameter here, specify the size of increment between the consecutive station numbers to be as-
signed. See the example below:
Example:
TEC: Telephone Equipment Class [1-31]
1=DP (10pps)2=PB
3=DP/PB4=DP (20pps)
5-11=Not used12=Dterm
13=Data Terminal via Dterm14=Hot Line
15=CAS Line16=Data Terminal via Data Module
17=Not used18=Virtual Line Appearance (for Dterm Multi-Line)
19-22=Not used23=ISDN Terminal
24-26=Not used27=8 Conference Equipment
28-31=Not used
RSC: Route Restriction Class [0-15]
SFC: Service Feature Class [0-15]
Buttons
Execute: Make the input data valid.
Cancel: Cancel the input data.
Exit: Exit this command.
Output Data (after Execute button is pressed)
TN: Tenant Number
STN: Assigned Station Number
LENS: Line Equipment Number
STATUS: Data Entry Result
OK=Data Assignment is successful
Note
Note:
If OK is not displayed (i.e. the data entry is not successful), related error message is displayed here.
INPUT DATA
RESULT
STN(START)=100 A Station Number is assigned by increments of 10:
-When asterisk (*) and number (#) are not used as part of STN
100 110 120 130... 190 200
-When asterisk (*) and number (#) are used as part of STN
10* 118 126 134... 1** 1#8
STN(END)=200
STEP=10
To Next Page
Loading...
