NEC UNIVERGE SV8500 - DTF105 Display of Route Peg Count Data

– 835 –
CHAPTER 7 Maintenance Commands
DTF105: Display of Route Peg Count Data
1. Functional Outline
This command is used to display the result of traffic measurement data for TYPE=5 (Route Peg Count) assigned
by the ATRF command.
2. Parameters
Traffic Data 1: Terminal Traffic-DTF101
Route Traffic-DTF102
Station Peg Count-DTF103
Attendant Peg Count-DTF104
Route Peg Count-DTF105
Traffic Data 2: Service Peg Count-DTF201
Traffic Data 3: UCD Route Peg Count-DTF301
UCD Group Peg Count-DTF302
UCD Station Peg Count-DTF303
Traffic Data 5: Attendant Ans. Peg Count-DTF501
Traffic Data 6: Connection Route Peg Count-DTF601
Connection Route Traffic-DTF602
Traffic Data 7: IP Service Peg Count - DTF701
IP Service Traffic - DTF702
Traffic Data 8: SIP Service Peg Count - DTF801
System Entire Peg Count
Each Server Peg Count