NEC UNIVERGE SV8500 - O Cyclic Diagnosis Normal

To Next Page

To Previous Page

– 294 –

CHAPTER 3 System Messages

7-O: Cyclic Diagnosis Normal

In a specific time cycle, the system allows a routine diagnosis in its hardware and software to determine if they

are operating properly. This message indicates that the system has been checked by the routine diagnosis

program and the result of the diagnosis is normal.

Performed Diagnosis Item

Note 1: The data in this area will be

diverse, according to the di-

agnosis specified in

. For

details on each item data,

see the following pages.

Note 2: This is output when a PS

line is accommodated on programmable line/feature key of the Dterm as a sub line.

Default Alarm Default Grade Grade Modified Lamp Modified

NON 3

1: XXXX XXXX XXXX XXXX 2: 0000 0000 0000 0000 3: 0000 0000 0000 0000

Note 1

4: 0000 0000 0000 0000 5: 0000 0000 0000 0000 6: 0000 0000 0000 0000

7: 0000 0000 0000 0000 8: 0000 0000 0000 0000 9: 0000 0000 0000 0000

b7 b6 b5 b4 b3 b2 b1 b0

[00H] Routine Diagnosis Start

[20H] Data Memory Verification Normal End

[30H] TSW ACT/STBY Changeover Normal End

[40H] CPU ACT/STBY Changeover Normal End

[50H] No Trunk Ineffective Hold

[51H] Accommodated Location of PS - No Trunk Ineffective Hold

Note 2

[70H] Call Forwarding Memory Clear Normal End

[A0H] Periodic Back-up Normal End

[C0H] Detection of Remaining Link Normal End

Other manuals for NEC UNIVERGE SV8500