– 792 –
CHAPTER 7 Maintenance Commands
DFTD: Display of System Message Details
1. Functional Outline
This command is necessary to print the system messages detected by Fault Diagnostic programs.
When the fault scanning (Scanning SV8500) is effective, PCPro can scan SV8500 status by polling every 20
seconds, (default setting is effective.) If the SV8500 has faults, this command executes automatically.
Up to 512 messages can be compiled on PCPro. After the number of compiled messages reaches the maximum
number, the coming message can not be obtained.
2. Parameters
Input data
New/Old
Show Details: Yes/No
To Next Page
Loading...
