– 795 –
CHAPTER 7 Maintenance Commands
DICBD: Display of Individual Call Block Data
1. Functional Outline
This command is used to display the information of Individual Call Block Data.
2. Parameters
Input Data
TYPE: Select the item to input data.
1: UGN/TELN
2: FPC/TN/STN
3: FPC/LENS
When “1: UGN/TELN” is selected in TYPE:
UGN: Enter the User Group Number.
TELN: Enter the Telephone Number (Maximum 16 digits).
When “2: FPC/TN/STN” is selected in TYPE:
FPC: Enter the Fusion Point Code.
TN: Enter the Tenant Number.
STN Enter the Station Number.
When “3: FPC/LENS” is selected in TYPE:
FPC: Enter the Fusion Point Code.
LENS: Enter the Equipment Number.
Output Data
CB ACT: Call Block List
0: Inactive
1: Active
AN BLK ACT: Anonymous Call Block
0: Inactive
1: Active
BIN NO: Bin Number [00-15]
DC: Denial DC Number (Maximum 16 digits)
Buttons
To Next Page
Loading...
