NEC UNIVERGE SV8500 - DLSL Display of Lockout Station - LENS

– 817 –
CHAPTER 7 Maintenance Commands
DLSL: Display of Lockout Station - LENS
1. Functional Outline
This command is used to print the LENS of stations in lockout state.
2. Parameters
Input data
Type: Type of Printout (1-3)
1=Printout of all LEN in lockout
2=Printout of locked out LEN in the designated Module Group
3=Printout of locked out LEN in the designated Unit
MG: Module Group Number
Note 1, Note 2
UNIT: Unit Number Note 2
Note 1:
The parameter is valid only when TYPE=2.
Note 2: The parameter is valid only when TYPE=3.
Output data
Index Index Number
LENS Line Equipment Number