– 121 –
CHAPTER 2 Operations of SV8500 Server
(6) Service Peg Count
The following shows Service Peg Count Listup Report and description of symbols in the report.
• Tandem : The number of incoming calls that directly provide tandem connection
(not via the Attendant Console)
• Others : The number obtained by subtracting “Attendant”, “Station” and “Tan-
dem” from “Incoming”. These calls include the following scenarios:
-Incoming calls terminated but released before the line is connected.
-Calls to unused numbers
• VT(E-CCIS) Establish-
ment [OUT]
: The number of call originations through Virtual Tie Line (E-CCIS).
• VT(E-CCIS) Establish-
ment [IN]
: The number of call terminations through Virtual Tie Line (E-CCIS).
• Call Hold : The number of times that the line is on hold with dialing access code
for CALL HOLD [C-6].
• Call Back : The number of times that CALL BACK [C-1] is set to the station with
dialing the access code for CALL BACK.
Note: The traffic data on the above report is an example.
113 9 1 3 6 0 6 0 1 50
Start Time: 10/27 16:21
End Time: 10/2716:25
10, 27, 2005
[LOCALHOST::DTFA]
* Display of Service Peg Count Data (DTF201) *
Call Hold
Tenant 1
Call Back Call Back Erow
Call Waiting
232120015
CFA Cancel
11021
Cancel
Originate
Call Waiting
Terminate
Call Pick Up
Direct Call
Pick Up
CFA Entry
CFB Entry CFB Cancel CFDA Entry CFDA
Cancel
System
Speed Call
Access
Individual
Speed Call
Access
Individual
Speed Call
Entry
TAS Answer
12 1 0 0
Off Hook On Hook On Hook
OG Queuing Queuing
Entry
Queuing
Cancel
Add On
Conference
Consult Hold
Call Transfer
000008
25
TRAFFIC MEASUREMENT
Page (UP) Page (Down)
Save Text File
To Next Page
Loading...
