– 900 –
CHAPTER 7 Maintenance Commands
RLST: Release Station/Trunk
1. Functional Outline
This command is used to release a station, trunk, or virtual trunk when using PHG circuit card.
When in-progress virtual trunk is not able to recover from a fault, this command is used to disconnect the in-
progress call forcefully due to the recovery.
2. Parameters
Input data
TYPE: Type of Select (1-5)
1=Stations
2=Trunk
3=LENS
4=Connection Trunk
5=Virtual Trunk
Note 1
TN: Tenant Number Note 2
STN: Station Number (maximum six digits) Note 2
RT: Route Number Note 3
TK: Trunk Number Note 3
LENS: Line Equipment Number Note 4
Connection RT: Connection Route Number (1-1023) Note 5
Connection TK: Connection Trunk Number (1-4095) Note 5
Note 1:
This option is valid when assigning 1 or 2 on CDN68: VIR by the ART command, indicating that the
WAN or MG connections are specified as virtual trunk identification data.
Note 2: This parameter is valid only when TYPE=1.
Note 3: This parameter is valid only when TYPE=2.
Note 4: This parameter is valid only when TYPE=3.
Note 5: This parameter is valid only when TYPE=4.
Output data
STATUS: Status of Station/Trunk (1-4)
0=Not Assigned
1=Idle
To Next Page
Loading...
