– 886 –
CHAPTER 7 Maintenance Commands
MBTC_LR: Make-Busy of Trunk-Continuous – Logical Route Number
1. Functional Outline
This command is used to assign the IDLE/BUSY status of trunks. By using this command, multiple trunks can
be placed into IDLE/BUSY state simultaneously per a logical route designated in LGRT parameter. Route
number of the MBTC command can be assigned by using logical route.
Note: When logging in to the Network Control Node (NCN), the data of other Local Node (LN) can be changed.
If logging in to a LN, only the DM of self-node can be changed by this command.
2. Parameters
Input Data
LGRT: Logical route number allocated to the Route Number. Note 1
TK: Trunk Number Note 2
START
END
MB: Make-Busy Information [0-2]
0=Make Idle
1=Make Busy (Outgoing)
2=Make Busy (Bothway)
Note 1: Prior to this command, logical route number must be allocated by using the ALRTN command.
Note 2: The status of plural trunks can be changed simultaneously, according to the range of trunk number as-
signed and per a logical route.
Output Data
FPC: Fusion Point Code [1-253]
RT: Route Number
To Next Page
Loading...
