– 536 –
CHAPTER 4 Fault Repair Procedures
1.3 IP Related System Messages and the Reasons
This section explains the situation when system messages shown below appeared with relation to the IP.
Because of the system characteristic, there will be faults related to system side equipment and other faults
(including the fault occurred on the network). Refer to system message and detailed data for the best treat-
ment. In a certain condition, alarm may not be released or the failure may not be solved by the operation
of procedure shown below.
Table 4-1 IP related System Messages
System Messages
Reference
33-R
FNC=02H, INF=04H, FLT=04H (Exceed number of maxi-
mum connection)
IP Related System Message and Its
Reason (33-R) on page 537
FNC=03H, INF=01H, FLT=02H (Excessive RTP packet
loss)
FNC=05H (Sequence error), INF=01/02H, FLT=xxH
FNC=05H, INF=04H, FLT=02H (Command re-send error)
33-S
FNC=02H, INF=01H, FLT=01H (Fall out of Ether (LAN)
cable)
IP Related System Message and Its
Reason (33-S) on page 539
FNC=05H (Sequence error), INF=01/02H, FLT=xxH
FNC=05H, INF=03H, FLT=01H (Health check error)
FNC=05H, INF=04H, FLT=02H (Command re-send error)
To Next Page
Loading...
