– 719 –
CHAPTER 7 Maintenance Commands
When DELETE is selected in the TYPE selection list box
Input Data
TN(START): First Tenant Number
TN(END): Last Tenant Number
STN(START): First Station Number [maximum six digits]
STN(END): Last Station Number [maximum six digits]
STEP: Station Count-up Step
Note 1
If using asterisk (*) and number (#) o [1-12]
If not using asterisk (*) and number (#) o [1-10]
Note 1: In this parameter, specify the size of increment between the consecutive station numbers deleted. See
the example below:
Example:
Buttons
Execute: Delete the input data.
Cancel: Cancel the deletion.
Exit: Exit this command.
Output Data
TN: Tenant Number
STN: Station Number
STATUS: Result of Deletion
Note 2
Note 2:
When the deletion is successful, OK is displayed. Otherwise (i.e. the deletion is rejected), related error
message is displayed.
INPUT
RESULT
STN(START)=100 Station Number is deleted by increments of 10:
When asterisk (*) and number (#) are not used as part of STN
100 110 120 130 ... 190 200
When * and # are used as part of STN
10* 118 126 134 ... 1** 1#8
STN(END)=200
STEP=10
To Next Page
Loading...
