– 724 –
CHAPTER 7 Maintenance Commands
When DELETE is selected in the TYPE/KIND selection list box
Input Data
RT: Route Number
TK(START): First Trunk Number [1-768]
TK(END): Last Trunk Number [1-768]
STEP: Trunk Count-up Step [1-10]
Note 1
Buttons
Execute: Delete the input data.
Cancel: Cancel the deletion.
Exit: Exit this command.
Output Data
TK: Trunk Number
STATUS: Result of Deletion
OK=Deletion Successful
Note 2
Note 1:
In this parameter, specify the size of increment between the consecutive trunk numbers deleted. See the
example below:
Example:
Note 2: When the deletion is successful, OK is displayed here. Otherwise (i.e. the deletion is rejected), related
error message is displayed.
INPUT DATA
RESULT
TK(START)=1 A Trunk Number is deleted by increments of 2:
TK(END)=21
STEP=2
To Next Page
Loading...
