– 765 –
CHAPTER 7 Maintenance Commands
<For the execution of the process>
PC Port Control: Select either “Connection” or “Disconnection”.
<Others>
All Select: Mark the checkbox when selecting all data in the list.
Auto Scroll: By marking the checkbox, the data in the list is automatically scrolled to the
end.
Note: By marking the checkboxes next to the numbers in the list, the individual readout data can be selected.
Output Data
No.: Each data in the list is numbered. (1-n)
Result: Status of the system
TN: Tenant Number (1-63)
STN: Station Number (Up to 16 digits (0-9, *, #))
LENS: Line Equipment Numbers
UGN (NDM): User Group Number (NDM) (1-255)
TELN (NDM): Telephone Number (NDM) (Up to 16 digits (0-9, *, #))
UGN (LDM): User Group Number (LDM) (1-255)
TELN (LDM): Telephone Number (LDM) (Up to 16 digits (0-9, *, #))
IP Address: IP address of Terminal (0.0.0.1 - 255.255.255.254)
Connection Status: Current status of the PC port (Connection/Disconnection)
Connection Status (LDM):Status of the PC port on the office data (Connection/Disconnection)
Buttons
Get: Readout the data
Execute: Start the process.
Skip: Cancel the data readout or the execution of the process.
Exit: Exit this command.
To Next Page
Loading...
