– INT-4 –
Note 2: MG(PRI) in Proprietary Protocol mode uses LAN1 as the registration destination while uses LAN2 as the
signaling control port. LAN interface for the signaling control port, however, can be changed to LAN1 by
ADTM command.
Note 3: “SIP terminal” excludes WLAN Handset (MH Series) here.
Note 4: When migrating from existing IPX/SV7000 to SV8500, LAN1/LAN2 can be selected as LAN interface for
IP equipment/terminals that use Proprietary Protocol mode. For the detail, refer to the Migration Manual.
To Next Page
Loading...
