– 439 –
CHAPTER 3 System Messages
Alarm-detected HW
Note: This data displays only when b4 is “1” and b3 is “0” in data .
Repair Procedure
Fault repair work is not required by the display of this message. If the message is created frequently, it is
recommended that the repair work be performed as shown in System Message [33-C] SDT Alarm Trouble.
b7 b6 b5 b4 b3 b2 b1 b0
The data here specifies the HW, on which any of the VC-11 Path
Trouble was detected in data . Note.
Refer to the table below:
2
3
b7 b6 b5 b4 b3 b2 b1 b0
----28272625
24 23 22 21 20 19 18 17
16 15 14 13 12 11 10 9
87654321
2
To Next Page
Loading...
