– 517 –
CHAPTER 3 System Messages
When = 01H (Reset Factor) is indicated
DTC
Block Number
Reset Factor
1: XXXX XXXX XXXX XXXX 2: XXXX XXXX 01XX XX00 3: XXXX XXXX XXXX XXXX
4: XXXX XXXX 0000 0000 5: 0000 0000 0000 0000 6: 0000 0000 0000 0000
7: 0000 0000 0000 0000 8: 0000 0000 0000 0000 9: 0000 0000 0000 0000
b7 b6 b5 b4 b3 b2 b1 b0
b7 b6 b5 b4 b3 b2 b1 b0
b7 b6 b5 b4 b3 b2 b1 b0
6
109
13
7
8
12
11
13
7
A maximum of Eight Blocks.
Note: Bits from Reset Factor to The number of blocks will be
output by the number of Block Number.
8
00H: Not used
01H: Autonomous Reset (before registration [DRS01: Initial Setting
Request])
02H: Autonomous Reset (during registration to the system [DRS03:
Signaling Path Set Response])
03H: Autonomous Reset (after registration and while setting initial values)
04H: Autonomous Reset (during call processing)
05H: Autonomous Reset (during partial initialization)
06H: Autonomous Reset
(diagnosis command not received/Keep-alive NG.)
07H: Software Reset
08H: DHCP lease is expired
09H: Configuration Mode is ended (only for DtermIP)
0AH: Reset Statement from PROTIMS (only for DtermIP)
0BH-FFH: Not used
For more details see Chapter 2 Detailed Information of Reset Factors.
9
To Next Page
Loading...
