– 708 –
CHAPTER 7 Maintenance Commands
Note 5: Available firmware version is 3.0.0.0 or later.
Note: This command does not support the following Terminal Types even if they are displayed in the Regis-
tered File Name List. Do not use the following Terminal Types and their additional information in the
list.
Terminal Type HWTP HWVER File Name
Dterm75/Series E w/ IP
Adaptor(P-P) or Dter-
mIP(Series E Mode)
00 02 ramhptop.hex
Dterm Series i w/ IP
Adaptor
00 12 ramhp2pr.hex
DtermIP 00 14 ramhp2pw.out
IP-CS(3ch) 31 - BPRG_IPBSA.DAT
IP-CS(6ch) 32 - BPRG_IPBSA.DAT
IP-ZT 34 00 BPRG_IPZT.DAT
IPVPS 51 00 -
Analog MG 61 - -
T1 MG 62 - -
To Next Page
Loading...
