– 732 –
CHAPTER 7 Maintenance Commands
<IP-BS>
ALL ITEMS ARE SELECTED: Selects all IP-BSs that are registered to the node which CBKS com-
mand is used toward. When “Selected terminal is reset” is clicked, all
IP-BSs that are read out can be reset.
TOTAL: Displays number of terminals that are read out.
List: Displays the registered IP-BS information such as FPC, TN, PCN,
ERN, GRN, CSN, LENS, HOME NODE FPC, and Reset Status when
“Get” is clicked.
When performing the reset of the specified IP-BS, click the check box
of appropriate IP-BS, and then click “Selected terminal is reset”.
<PS>
ALL ITEMS ARE SELECTED: Selects all PSs whose operations are controlled by the node which
CBKS command is used toward. When “Selected terminal is reset” is
clicked, all PSs that are read out can return to Primary Node.
TOTAL: Displays number of terminals that are read out.
List: Displays the PS information such as UGN, TELN, TN, STN, FPC,
LENS, HOME NODE FPC, and Reset Status when “Get” is clicked.
Click the check box of appropriate PS, and then click “Selected termi-
nal is reset” to place the PS back into Primary Node.
Note: TN and LENS are not displayed for terminal information that are not registered to the node which CBKS
command is used toward.
Note: Cannot reset the terminals that are not registered to the node which CBKS command is used toward.
To Next Page
Loading...
