– 742 –
CHAPTER 7 Maintenance Commands
Enter the IP address of SR-MGC, not the default IP address but the actual IP address to be allocated to the
target SR-MGC. In the case of two-unit SR-MGC, assign IP address of the SR T.
Mode:
The type of changeover and recovery is to be executed.
1 = Automatically switched to SR-MGC operation when communication failure has been detected be-
tween MGC and SR-MGC.
Automatically switched back to MGC operation when communication recovery has been detected be-
tween MGC and SR-MGC.
In FCCS Cluster network, if SR-MGC detects normality of communication between SR-MGC and
Primary node or SR-MGC and Backup nodes, SR-MGC will switch the rescued terminals back to the
recovered node.
2 = Automatically switched to SR-MGC operation when communication failure has been detected be-
tween MGC and SR-MGC.
Automatically switched back to MGC operation when communication recovery between MGC and
SR-MGC, and normality of communication between MGC and a selected terminal have been detect-
ed.
In FCCS Cluster network, if SR-MGC detects normality of communication between SR-MGC and
Primary node, Primary node and a selected terminal, SR-MGC will switch the rescued terminals back
to the Primary node.
3 = Not used.
C_MGC:
Select an Operating Mode for SR-MGC.
0 = Normal Operation
1 = Office data cannot be copied from the MGC when FCCS Cluster feature is used. This value must be
assigned to the Backup nodes used in FCCS Cluster network.
<Initialize Tab>
Initialization of SR-MGC can be activated on this tab.
Click either of the radio buttons and press the Execute button to execute initialization on the target SR-MGC.
All Initial:
Select this button to execute the initialization on all the SR-MGCs in the network (default setting).
Individual Initial:
Specify the SR-MGC Number when this button is selected.
<Change Operating Tab>
To Next Page
Loading...
