– 770 –
CHAPTER 7 Maintenance Commands
2. Parameters
CSV File
File Name: Read out CSV file name is displayed.
File Read button
When using the saved CSV file already having got the registered data, read the CSV file out on
PCPro. Click File Read button to open File Open dialog box, and then specify the target CSV file.
File Write button
The data listed on the Data field is saved as a CSV file on PCPro. Click File Write button to open
Save As dialog box, and then save the CSV file.
GET TYPE
Select ALL TYPE or RANGE TYPE in the drop-down list to set the range of registered data to be read out
and listed in Data field.
• ALL TYPE: All the registered data is to be listed.
• RANGE TYPE: Registered data is to be listed specifying the range by TN and ACC.
TN (Tenant Number): Set the range by entering START TN and END TN [1-63].
ACC (Access Code): Set the range by entering START ACC and END ACC [Up to six digits].
Data
ALL SELECT
Place a checkmark to delete all the listed data.
Indicate from CNT to SRV
Place a checkmark to set the parameters CNT through SRV are to be listed.
Note: Regardless of the checkmark ON/OFF selected, STATUS field is always displayed.
<Details on parameters listed>
CNT: Number of lines Note 1
TN: Tenant Number
ACC: Access Code
CI: Connection Status Index
SRV: Kind of Service
SID: Service Index
SIDA: Service Index A
NND: Necessary Digit
To Next Page
Loading...
