– 774 –
CHAPTER 7 Maintenance Commands
Select ALL TYPE or RANGE TYPE in the drop-down list to set the range of registered data to be read out
and listed in Data field.
• ALL TYPE: All the registered data is to be listed.
• RANGE TYPE: Registered data is to be listed specifying the range by TN and ACC.
TN (Tenant Number): Set the range by entering START TN and END TN [1-63].
ACC (Access Code): Set the range by entering START ACC and END ACC [Up to six digits].
Data
ALL SELECT
Place a checkmark to delete all the listed data.
Indicate from CNT to SRV
Place a checkmark to set the parameters CNT through SRV are to be listed.
Note: Regardless of the checkmark ON/OFF selected, STATUS field is always displayed.
<Details on parameters listed>
CNT: Number of lines Note 1
TN: Tenant Number
ACC: Access Code
CI: Connection Status Index
SRV: Kind of Service
SID: Service Index
SIDA: Service Index A
NND: Necessary Digit
NND1: Necessary Digit for Speed Calling
FPC: Fusion Point Code
STATE: Hotel Service Code
NO1: Kind of Assignment Number
NO2: Kind of Assignment Number
KIND: Kind of Function
PNO: Pattern Number for AOSP command
A/G: Admin/Guest
LGRT: Logical Route Number
2nd DT: Second Dial Tone
AH: Authorization Code
To Next Page
Loading...
