NEC UNIVERGE SV8500 - Page 859

– 812 –
CHAPTER 7 Maintenance Commands
(e) When 5: IP Trunk Status Read is selected;
CNT
Target IP Address
Target Port Number
Self Port Number
Active Mode
Connect Mode
Time of Connection Lost (minute)
Connection Status
(f) When 6: Terminal Data of IPELC Read is selected;
IP Address
Jitter Buffer Minimum (x 10 milliseconds)
Jitter Buffer Maximum (x 10 milliseconds)
Jitter Buffer Size (x 10 milliseconds)
Jitter Buffer Consumption (x 10 milliseconds)
(g) When TYPE = 7: Traffic Data of IPELC Read and KIND = 1 are selected;
[Receive]
Packets
CRC Error (RMD)
Collision
Ethernet Controller Framing Error
No Receive Buffer
No PCI Bridge SDRAM Space
Bus Parity Error
[Send]
Packets
No PCI Bridge SDRAM Space TMD
Ethernet Controller FIFO Underflow
Ethernet Controller Delay
Ethernet Controller Carrier Loss
Ethernet Controller Retry NG
Bus Parity Error
[Receive Packet Details]
Receive Packet (less than 64 bytes)
Receive Packet (64-127 bytes)
Receive Packet (128-255 bytes)
Receive Packet (256-511 bytes)
Receive Packet (512-1023 bytes)
Receive Packet (1024-1528 bytes)
Receive Packet (more than 1528 bytes)
(h) When TYPE = 7: Traffic Data of IPELC Read and KIND = 2 are selected;