– 869 –
CHAPTER 7 Maintenance Commands
<PHC Point Code tab>
[Input Data]
Specify the range of Point Code in the START Remote PC and END Remote PC [1-16367].
[Output Data]
Office: Self office / Destination office
PC: Point Code of the office
IP Address
PH LENS: LENS of the PHC card in the self office (displayed for self office only)
Ping result (system-0)
Ping result (system-1)
<SR-MGC tab>
[Output Data]
SR-MGC Number [1-255]
IP Address
Connect CNT: The number of connected IP terminals in the remote office
Office Name
Ping result (system-0)
Ping result (system-1)
To Next Page
Loading...
