NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-42 Switching Commands
202-10102-01, May 2005
Note: This is a stand-alone “no” command. This command does not have a “normal” form. This
command can be issued without regard for the session status (enabled or disabled).
Default
enabled
Format no monitor session <session-id>
Mode Global config
show monitor session 1
This command displays the Port monitoring information for a particular mirroring session.
Note: The <session-id> parameter is an integer value used to identify the session. In the current
version of the software, the <session-id> parameter is always 1.
Format
show monitor session <session-id>
Mode Privileged EXEC
The following is the explanation of the output parameters for this command:
Session ID It is an integer value used to identify the session. Its value can be anything
between 1 and L7_MIRRORING_MAX_SESSIONS.
Monitor Session Mode
It indicates whether the Port Mirroring feature is enabled or
disabled for the session identified with <session-id>. The
possible values are Enabled and Disabled.
Probe Port It is the probe port (destination port) for the session identified
with <session-id>. If probe port is not set then this field is
blank.
List of source Ports It is the list of ports, which are configured as mirrored ports (source
ports) for the session identified with <session-id>. If no source port is configured for the session
then this field is blank.
shutdown
This command disables a port.
Default
enabled
Format shutdown
Mode Interface Config