User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-26 Switching Commands
202-10102-01, May 2005
Mode Privileged EXEC
SNMP Community Name The community string to which this entry grants access. A valid entry
is a case-sensitive alphanumeric string of up to 16 characters. Each row
of this table must contain a unique community name.
Client IP Address - An IP address (or portion thereof) from which this device will accept
SNMP packets with the associated community. The requesting entity's
IP address is ANDed with the Subnet Mask before being compared to
the IP Address. Note: that if the Subnet Mask is set to 0.0.0.0, an IP
Address of 0.0.0.0 matches all IP addresses. The default value is 0.0.0.0
Client IP Mask - A mask to be ANDed with the requesting entity's IP address before
comparison with IP Address. If the result matches with IP Address then
the address is an authenticated IP address. For example, if the IP
Address = 9.47.128.0 and the corresponding Subnet Mask =
255.255.255.0 a range of incoming IP addresses would match, i.e. the
incoming IP Address could equal 9.47.128.0 - 9.47.128.255. The default
value is 0.0.0.0
Access Mode The access level for this community string.
Status The status of this community access entry.
show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an
SNMP Network Manager. These messages alert the manager to events occurring within the switch
or on the network. Six trap receivers are simultaneously supported.
Format
show snmptrap
Mode Privileged EXEC
SNMP Trap Name The community string of the SNMP trap packet sent to the trap man-
ager. This may be up to 16 alphanumeric characters. This string is case
sensitive.
IP Address The IP address to receive SNMP traps from this device. Enter four num-
bers between 0 and 255 separated by periods.
Status Indicates the receiver's status (enabled or disabled).
To Next Page
Loading...
