NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-129
202-10102-01, May 2005
Bridge Max Hops Bridge max-hops count for the device.
Bridge Hello Time Configured value.
Bridge Forward Delay Configured value.
Bridge Hold Time Minimum time between transmission of Configuration Bridge Protocol
Data Units (BPDUs)
show spanning-tree summary
This command displays spanning tree settings and parameters for the switch. The following details
are displayed on execution of the command.
Format
show spanning-tree summary
Modes Privileged EXEC
User EXEC
Spanning Tree Adminmode Enabled or disabled.
Spanning Tree Version Version of 802.1 currently supported (IEEE 802.1s, IEEE 802.1w, or
IEEE 802.1d) based upon the Force Protocol Version parameter.
Configuration Name Identifier used to identify the configuration currently being used.
Configuration Revision Level Identifier used to identify the configuration currently being
used.
Configuration Digest Key Identifier used to identify the configuration currently being used.
MST Instances List of all multiple spanning tree instances configured on the switch
show spanning-tree interface
This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot/port> is the desired switch port. The following details are
displayed on execution of the command.
Format
show spanning-tree interface <slot/port>
Mode Privileged EXEC
User EXEC
Hello Time Admin hello time for this port.
Port mode Enabled or disabled.