NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
10-14 Quality of Service (QoS) Commands
202-10102-01, May 2005
match cos
This command adds to the specified class definition a match condition for the Class of Service
value (the only tag in a single tagged packet or the first or outer 802.1Q tag of a double VLAN
tagged packet). The value may be from 0 to 7.
Default
none
Format match cos <0-7>
Mode Class-Map Config
match destination-address mac
This command adds to the specified class definition a match condition based on the destination
MAC address of a packet. The <macaddr>
parameter is any layer 2 MAC address formatted as six,
two-digit hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The <
macmask>
parameter is a layer 2 MAC address bit mask, which need not be contiguous, and is formatted as
six, two-digit hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc).
Default
none
Format match destination-address mac <macaddr> <macmask>
Mode Class-Map Config
match dstip
This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The <ipaddr>
parameter specifies an IP address. The <ipmask> parameter
specifies an IP address bit mask and must consist of a contiguous set of leading 1 bits.
Default
none
Format match dstip <ipaddr> <ipmask>
Mode Class-Map Config
match dstl4port
This command adds to the specified class definition a match condition based on the destination
layer 4 port of a packet using a single keyword or numeric notation.