NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-95
202-10102-01, May 2005
dvlan-tunnel customer-id
This command configures the customer identification for the Double VLAN tunnel on the
specified interface. The customer ID may have the value 0 to 4095. The default value of the
customer ID is 0.
Default
0
Format dvlan-tunnel customer-id <0-4095>
Mode Interface Config
no dvlan-tunnel customer-id
This command configures the customer identification for the Double VLAN tunnel on the
specified interface to its default value.
Format
no dvlan-tunnel customer-id
Mode Interface Config
dvlan-tunnel etherType
This command configures the ether-type for the specified interface. The ether-type may have the
values of 802.1Q, vMAN, or custom. If the ether-type has a value of custom, the optional value of
the custom ether type must be set to a value from 0 to 65535.
Default
vman
Format dvlan-tunnel etherType <802.1Q | vman | custom> [0-
65535]
Mode Interface Config
no dvlan-tunnel etherType
This command configures the ether-type for the specified interface to its default value.
Format
no dvlan-tunnel etherType
Mode Interface Config