NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
10-12 Quality of Service (QoS) Commands
202-10102-01, May 2005
Format class-map rename <class-map-name> <new-class-map-
name>
Mode Global Config
match ethertype
This command adds to the specified class definition a match condition based on the value of the
ethertype. The <ethertype
> value is specified as one of the following keywords: appletalk, arp, ibmsna,
ipv4, ipv6, ipx, mplsmcast, mplsucast, netbios, novell, pppoe, rarp or as a custom ethertype value in the range of
0x0600-0xFFFF.
Format match ethertype {<keyword> | custom <0x0600-0xFFFF>}
Mode Class-Map Config
match secondary-cos
This command adds to the specified class definition a match condition for the secondary Class of
Service value (the inner 802.1Q tag of a double VLAN tagged packet). The value may be from 0 to
7.
Format
match [not] secondary-cos <0-7>
Mode Class-Map Config
match secondary-vlan
This command adds to the specified class definition a match condition for the secondary VLAN
identifier value (the inner 802.1Q tag of a double VLAN tagged packet). The range from
vlanmin
and vlanmax
are integers from 1 to 4095 with vlanmax being optional.
Format
match [not] secondary-vlan <vlanmin> [<vlanmax>]
Mode Class-Map Config
match any
This command adds to the specified class definition a match condition whereby all packets are
considered to belong to the class.
Default
none
Format match any