User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Quality of Service (QoS) Commands 10-33
202-10102-01, May 2005
show classofservice trust
This command displays the current trust mode setting for a specific interface. The slot/port
parameter is optional and is only valid on platforms that support independent per-port class of
service mappings. If specified, the port trust mode of the interface is displayed. If omitted, the
most recent global configuration settings are displayed.
Format
show classofservice trust [slot/port]
Mode Privileged EXEC
Non-IP Traffic Class The traffic class used for non-IP traffic. This is only displayed when the
COS trust mode is set to trust ip-precedence.
Untrusted Traffic Class The traffic class used for all untrusted traffic. This is only displayed
when the COS trust mode is set to 'untrusted'.
show interfaces cos-queue
This command displays the class-of-service queue configuration for the specified interface. The
slot/port parameter is optional and is only valid on platforms that support independent per-port
class of service mappings. If specified, the class-of-service queue configuration of the interface is
displayed. If omitted, the most recent global configuration settings are displayed.
Format
show interfaces cos-queue [slot/port]
Mode Privileged EXEC
Interface This displays the slot/port of the interface. If displaying the global con-
figuration, this output line is replaced with a Global Config indication.
Intf Shaping Rate The maximum transmission bandwidth limit for the interface as a
whole. It is independent of any per-queue maximum bandwidth
value(s) in effect for the interface. This is a configured value.
The following information is repeated for each queue on the interface.
Queue Id
An interface supports n queues numbered 0 to (n-1). The specific n
value is platform dependent.
Minimum Bandwidth The minimum transmission bandwidth guarantee for the queue,
expressed as a percentage. A value of 0 means bandwidth is not guaran-
teed and the queue operates using best-effort. This is a configured
value.
Scheduler Type Indicates whether this queue is scheduled for transmission using a strict
priority or a weighted scheme. This is a configured value.
Queue Mgmt Type The queue depth management technique used for this queue (tail drop ).
To Next Page
Loading...
