NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Security Commands 9-19
202-10102-01, May 2005
Note: The secret must be an alphanumeric value not exceeding 16 characters.
Format
radius server key {auth | acct} <ipaddr>
Mode Global Config
radius server msgauth
This command enables the message authenticator attribute for a specified server.
Default
radius server msgauth <ipaddr>
Mode Global Config
radius server primary
This command is used to configure the primary RADIUS authentication server for this RADIUS
client. The primary server is the one that is used by default for handling RADIUS requests. The
remaining configured servers are only used if the primary server cannot be reached. A maximum
of three servers can be configured on each client. Only one of these servers can be configured as
the primary. If a primary server is already configured prior to this command being executed, the
server specified by the IP address specified used in this command will become the new primary
server. The IP address must match that of a previously configured RADIUS authentication server.
Format
radius server primary <ipaddr>
Mode Global Config
radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted when no
response is received from the RADIUS server. The retries value is an integer in the range of 1 to
15.
Default
4
Format radius server retransmit <retries>
Mode Global Config
no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, to the default
value.