NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-80 Switching Commands
202-10102-01, May 2005
no users passwd
This command sets the password of an existing operator to blank. When a password is changed, a
prompt will ask for the operator's former password. If none, press enter.
Format
no users passwd <username>
Mode Global Config
users snmpv3 accessmode
This command specifies the snmpv3 access privileges for the specified login user. The valid
accessmode values are
readonly or readwrite. The <username> is the login user name for which
the specified access mode applies. The default is
readwrite for ‘admin’ user; readonly for all
other users
Default
admin -- readwrite; other -- readonly
Format users snmpv3 accessmode <username> <readonly | read-
write>
Mode Global Config
no users snmpv3 accessmode
This command sets the snmpv3 access privileges for the specified login user as readwrite for the
‘admin’ user; readonly for all other users. The <username> is the login user name for which the
specified access mode will apply.
Format
no users snmpv3 accessmode <username>
Mode Global Config
users snmpv3 authentication
This command specifies the authentication protocol to be used for the specified login user. The valid authentication
protocols are none, md5 or sha.
If md5 or sha are specified, the user login password is also used as the
snmpv3 authentication password and therefore must be at least eight characters in length. The
<
username> is the login user name associated with the authentication protocol.
Default
no authentication
Format users snmpv3 authentication <username> <none | md5 |
sha>
Mode Global Config